LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1833 (Antilock Brake System And TCS) >> Diagnostic Information and Procedures >> DTC C0110 >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 3:  This step tests the pump motor circuits of the BPMV for a short to the housing of the BPMV.
DTC C0110

Step Action Value(s) Yes No
Connector End View Reference: Antilock Brake System Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Disconnect the electronic brake control module (EBCM) harness connector.
  2. Test both ground circuits of the EBCM including the EBCM ground for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs .
  3. Test the battery positive voltage circuits for an open, high resistance, or a short to ground. Refer to Circuit Testing and Wiring Repairs .
 Did you find and correct the condition?		 - Go to Step 8  Go to Step 3 
3 
  1. Disconnect the brake pressure modulator valve (BPMV) pump motor connector from the EBCM to gain access to the pump motor circuits.
  2. Measure the resistance between each pump motor control circuit and the housing of the BPMV.
Does the resistance measure less than the specified value?		 5 Ω Go to Step 4  Go to Step 5 
4 Inspect for poor connections at the pump motor connector of the BPMV. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?		 - Go to Step 8  Go to Step 6 
5 Inspect for poor connections at the harness connector of the EBCM. Refer Testing for Intermittent Conditions and Poor Connections to Connector Repairs .
Did you find and correct the condition?		 - Go to Step 8  Go to Step 7 
6 Replace the BPMV. Refer to Brake Modulator Assembly Replacement .
Did you complete the repair?		 - Go to Step 8  -
7 Replace the EBCM. Refer to Control Module References for replacement, setup, and programming.
Did you complete the repair?		 - Go to Step 8  -
8
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals