LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1831 (Instrument Panel System Displays And Gauges) >> Repair Instructions >> Instrument Cluster Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Instrument Panel Cluster
    GM891893Courtesy of GENERAL MOTORS CORP.
  1. Connect the I/P cluster harness.
    2. NOTE: Refer to Fastener Notice .
  2. Install the I/P cluster in the I/P housing. Install and tighten the fasteners.

    Tighten:  Tighten the fasteners to 2 N.m (18 lb in).

  3. Install the I/P cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement .
  4. Enable the SIR system. Refer to SIR Disabling and Enabling .
  5. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals