Removal Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the I/P cluster. Refer to Instrument Cluster Replacement .
- Place an anti-static mat on the work area. In order to ground the mat, connect the alligator clip to a large metal object. Verify that the attaching point is a bare metal surface and not painted or coated. Secure the wrist strap around one of your wrists.
- Place a clean, dry, soft material such as a cloth baby diaper on top of the anti-static mat.
- Place the I/P cluster assembly face down on the cloth and the anti-static mat.
- Using a 1/4-inch socket or a small flat-bladed tool, rotate the bulb base 1/4 turn counter-clockwise. Remove the bulb.
NOTE:
Failure to use the anti-static mat SA9502Z properly may result in damage to the cluster electronics.
IMPORTANT:
If the lens/mask gets dirty, clean the lens by following the procedure in the Owner's Handbook.
IMPORTANT:
Rubber gloves should be worn during these procedures to prevent grease, smudges, scratches, and fingerprints. If rubber gloves are not available, clean your hands thoroughly with soap and water.