LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1830 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission from the vehicle. Refer to Transmission Replacement .
  2. Remove the transmission side cover. Refer to Case Side Cover Replacement .
  3. Remove the control valve body. Refer to Control Valve Body Replacement .
    4. Fig 1: View Of Transmission Wiring Harness
    GM55101Courtesy of GENERAL MOTORS CORP.
  4. Push the J 41101  onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector's retaining tabs. See Special Tools .
  5. With the retaining tabs compressed, use a screwdriver in order to remove the pass-through connector through the inside of the transmission case.
  6. Remove the wiring harness (11).
scientia non olet · About LEMON Manuals