LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1830 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Park/Neutral Position Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped with 2.4L (LAT), remove the battery tray. Refer to Battery Tray Replacement (2.2L (L61)) or Battery Tray Replacement (2.4L (LAT)) or Battery Tray Replacement (3.5L (L66)) .
    2. Fig 1: Disconnecting/Connecting Shift Control Cable At Range Select Lever & Bracket
    GM1547449Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the shift control cable (3) from the range select lever (4).
  3. Release the shift control cable retaining clip (2) and remove the cable from the shift control cable bracket (1).
    4. Fig 2: Removing/Installing Transaxle Range Select Lever At Manual Shaft
    GM1547451Courtesy of GENERAL MOTORS CORP.
  4. Remove the transaxle range select lever nut (2).
  5. Remove the transaxle range select lever (3) from the transaxle manual shaft (1).
    6. Fig 3: Removing/Installing PNP Switch At Transaxle
    GM1547448Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the PNP switch electrical connector (3) from the PNP switch (4).
  7. Remove the PNP switch bolt (2) and stud (1).
  8. Remove the PNP switch (4) from the transaxle.
scientia non olet · About LEMON Manuals