LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1830 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Oil Feed Pipes Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission oil filter assembly. Refer to Automatic Transmission Fluid Filter and Seal Replacement .
    2. Fig 1: View Of Oil Feed Pipe Bolts
    GM104550Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil feed pipe bolts.
  3. Inspect the eight oil feed pipe seal rings.
  4. Replace the seal rings only if the seal rings are cut, swollen or damaged.
    5. Fig 2: Identifying Lo & Reverse Band Oil Pipe Assembly Seals
    GM104551Courtesy of GENERAL MOTORS CORP.
  5. Remove the lo and the reverse band oil pipe assembly.
  6. Remove the eight lo and the reverse band oil pipe assembly seals.
  7. Inspect the oil feed pipes for plugged passages, bent pipes, or cracks.
  8. Inspect the oil feed pipe seal rings. Verify the proper location of the seal rings. Replace the seal rings if these are cut, swelled or damaged.
scientia non olet · About LEMON Manuals