Transmission Fluid Auxiliary Pump Removal (L4 Hybrid Only)
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Hold the check valve (227) in its assembled position with a wrench and loosen the outlet pipe (229) nut from the check valve (227).
- Remove the upper suction pipe, M8 x 1.25 x 25 mm bolt (132) from the auxiliary pump (225).
- Remove the 4 auxiliary pump, M8 x 1.25 x 30 mm bolts (131).
- Disconnect the electrical connector.
- Remove the complete auxiliary pump (225) and check valve (227) assembly.
- Remove the outlet pipe, M8 x 1.25 x 25 mm, Bolt (132) and outlet pipe (229) from the case assembly.
- Remove the lower suction pipe, M8 x 1.25 x 25 mm bolt (132) and suction pipe (231) from the case assembly.
NOTE:
Use care to restrain the check valve when removing the outlet pipe. Restrain while the nut is loosened or damage may occur.
NOTE:
Do not bend the electrical connector or clip or damage may occur. The electrical connector and clip are one piece.