LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1830 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Output Shaft Speed Sensor Installation

Output Shaft Speed Sensor Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vehicle Speed Sensor Components
    GM25656Courtesy of GENERAL MOTORS CORP.
  1. Inspect the vehicle speed sensor (62) for damage to the sensor, the electrical connector, or the O-ring (63).
  2. Clean and dry the vehicle speed sensor (62).
    3. Fig 2: Locating Output Shaft Speed Sensor
    GM20830Courtesy of GENERAL MOTORS CORP.
  3. Install the O-ring (63) onto the speed sensor (62).
  4. Install the speed sensor (62) into the transmission case.
    5. NOTE: Refer to FASTENER NOTICE .
  5. Install the speed sensor stud (61).

    Tighten:  Tighten the speed sensor stud to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals