Output Shaft Removal

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 6125-1B Slide Hammer with Adapter. See Special Tools .
J 38868 Output Shaft Assembly Remover and Installer. See Special Tools .

Fig 1: Identifying Output Shaft Snap Ring

Courtesy of GENERAL MOTORS CORP.

Remove the snap ring (57).

Fig 2: Identifying J 6125-1B & J 38868 On Output Shaft

Courtesy of GENERAL MOTORS CORP.

Install the J 6125-1B and J 38868 on the output shaft (94). See Special Tools .
Use a screw driver to pry up on the shaft to take up the slack, then pull up on the slide hammer.