LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1830 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Forward Clutch Support, Low Roller Clutch Removal >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

J 28585  Snap Ring Screwdriver. See Special Tools .

    Fig 1: Identifying Forward Clutch Support Snap Ring
    GM1644739Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The snap ring opening must be at the bottom of the transmission case. If the snap ring opening is out of position, inspect the transmission case for damage.
  1. Remove the forward clutch support snap ring (112) from the transmission case. Use the J 28585  or equivalent. See Special Tools .
    2. Fig 2: Identifying Forward Clutch Support & Low Roller Clutch Assembly
    GM1644742Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: You may need to depress the parking pawl in order to remove the forward clutch support.
  2. Remove the forward clutch support and the low roller clutch assembly (114). Keep the forward clutch housing to the forward clutch support thrust bearing (113) with the forward clutch support assembly (114).
scientia non olet · About LEMON Manuals