Drive Sprocket Support Assemble

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 23327 Clutch Spring Compressor. See Special Tools .
J 41232 Return Spring Compressor. See Special Tools .

Fig 1: Identifying 2nd Clutch Piston And Seal Assembly

Courtesy of GENERAL MOTORS CORP.

In order to aid in the assembly, lubricate the seal with transmission fluid.
Assemble the 2nd clutch piston and seal assembly (404) into the driven sprocket support (401).
Assemble the 2nd clutch spring and retainer assembly (405) into the driven sprocket support.

Fig 2: View Of 2nd Clutch Spring Retainer Snap Ring

Courtesy of GENERAL MOTORS CORP.

Compress the 2nd clutch spring assembly. Use the J 41232 and J 23327 or equivalent. See Special Tools .
Assemble the 2nd clutch spring retainer snap ring (406).
Remove the J 41232 and J 23327 . See Special Tools .

Fig 3: Locating Seal Rings On Driven Sprocket Support

Courtesy of GENERAL MOTORS CORP.

Assemble two new seal rings (403) onto the driven sprocket support.