LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Rear Mount Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Transmission Mount-To-Frame Bolts
    GM1260852Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear transmission mount. Refer to Transmission Rear Mount Replacement .
    2. Fig 2: Removing/Installing Steering Shaft To Intermediate Shaft
    GM927947Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the intermediate steering shaft from the steering gear.
    3. Fig 3: View Of Steering Gear & Steering Gear-To-Frame Bolts
    GM927957Courtesy of GENERAL MOTORS CORP.
  3. Remove the steering gear to frame bolts.
  4. Secure the steering gear upward in order to gain additional clearance.
  5. Remove the HO2S sensor. Refer to Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 .
    6. Fig 4: Rear Transmission Mount Bracket To Transmission Bolts
    GM1239259Courtesy of GENERAL MOTORS CORP.
  6. Remove the transmission mount bracket to transmission bolts.
  7. Remove the transmission mount bracket from the vehicle.
scientia non olet · About LEMON Manuals