LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Output Shaft Oil Seal & Transmission Case
    GM1227144Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The seal must install flush with the case flange.
  1. Using the J 43068  , install the transmission output shaft oil seal into the transmission case. See Special Tools .
  2. Install the drive axle assembly. Refer to Front Wheel Drive Shaft Replacement (Non Hybrid) or Front Wheel Drive Shaft Replacement (Hybrid) .
  3. Lower the vehicle.
  4. Check the transaxle fluid level. Refer to Transmission Fluid Checking .
scientia non olet · About LEMON Manuals