LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Front Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Transmission Mount Bracket Top & Nut
    GM1260818Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the front transmission mount bracket top nut.

    Tighten:  Tighten the nut to 90 N.m (64 lb ft).

  2. Install the transmission mount/mount bracket.
  3. Fig 2: Front Transmission Mount Bracket-To-Transmission Bolts
    GM1239268Courtesy of GENERAL MOTORS CORP.
  4. Install the transmission mount bracket-to-transmission bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  5. Fig 3: View Of Front Transmission Mount-To-Frame Bolts
    GM1239273Courtesy of GENERAL MOTORS CORP.
  6. Install the transmission mount-to-frame bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  7. Install the starter motor. Refer to Starter Motor Replacement (2.2L (L61)) or Starter Motor Replacement (2.4L (LAT)) or Starter Motor Replacement (3.5L (L66)) .
  8. Install the transmission oil level indicator tube. Refer to Transmission Oil Level Indicator Tube Replacement .
  9. Reconnect the oxygen sensor connector.
  10. Install the battery tray. Refer to Battery Tray Replacement (2.2L (L61)) or Battery Tray Replacement (2.4L (LAT)) or Battery Tray Replacement (3.5L (L66)) .