LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Output Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Input/Output Speed Sensor, Bolt & Screw
    GM1230002Courtesy of GENERAL MOTORS CORP.
  1. Apply automatic transmission fluid to the new output speed sensor O-ring seal.
  2. Install the new output speed sensor O-ring seal onto the output speed sensor.
  3. Install the output speed sensor into the transmission case assembly.
    4. NOTE: Refer to Fastener Notice .
  4. Install the output speed sensor bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  5. Connect the wiring harness to the output speed sensor.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals