LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Output Shaft End Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation .
  2. Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  3. Remove the output shaft end cover bolts (3).
    4. Fig 1: End Cover Seal & Components
    GM1227150Courtesy of GENERAL MOTORS CORP.
  4. Remove the output shaft end cover (2) from the transmission.
  5. Remove the output shaft end cover seal (1) from the transmission and discard.
scientia non olet · About LEMON Manuals