LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Mainshaft End Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: End Cover Seal & Components
    GM1227150Courtesy of GENERAL MOTORS CORP.
  1. Install a new mainshaft end cover seal (6).
    2. NOTE: Refer to Fastener Notice .
  2. Install the mainshaft end cover (4) to the transmission.

    Tighten:  Tighten the mainshaft end cover bolts to 19 N.m (14 lb ft).

  3. Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  4. Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals