LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Input/Output Speed Sensor, Bolt & Screw
    GM1230002Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the wiring harness from the input speed sensor.
    3. IMPORTANT: Do not damage the input speed sensor or transaxle case.
  3. Remove the input speed sensor bolt/screw.
  4. Remove the input speed sensor, and the input speed sensor O-ring.
scientia non olet · About LEMON Manuals