LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transaxle Range Switch Lever Nut, Lock Nut, Washer & Lever
    GM1233354Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the transaxle range switch lever (1), washer (2) lock washer (3), and lever nut (4).

    Tighten:  Tighten the transaxle range switch lever nut to 16 N.m (12 lb ft).

  2. Snap the cable end fitting onto the ball stud of the transaxle range switch lever. An audible snap will be heard when properly installed.
  3. Install the battery tray and bracket. Refer to Battery Tray Replacement (2.2L (L61)) or Battery Tray Replacement (2.4L (LAT)) or Battery Tray Replacement (3.5L (L66)) .
  4. Install the battery. Refer to Battery Replacement (2.2L (L61) and 3.5L (L66)) or Battery Replacement (2.4L (LAT)) .
  5. Install the range selective lever bolt and cover.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  6. Install the left splash shield. Refer to Engine Splash Shield Replacement .
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals