LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> A/B Clutch Pressure Control Solenoid Assembly Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Solenoid Assembly Cover, Gasket & Bolts Removed
    GM1234198Courtesy of GENERAL MOTORS CORP.
  1. Install a new solenoid assembly cover gasket.
  2. Install the solenoid assembly cover.
    3. NOTE: Refer to Fastener Notice .
  3. Install the solenoid assembly cover bolts.

    Tighten:  Tighten the solenoid assembly cover bolts to 12 N.m (106 lb in).

  4. Install the feed pipes to the original locations and orientation.
  5. Install the A/B clutch pressure control solenoid assembly. Refer to A/B Clutch Pressure Control Solenoid Assembly Replacement .
scientia non olet · About LEMON Manuals