LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Wiring Harness Installation

Wiring Harness Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Automatic Transmission Wiring Harness, Bolt & O-Ring
    GM1203350Courtesy of GENERAL MOTORS CORP.
  1. Install an automatic transmission wiring harness O-ring seal (3) on the automatic transmission wiring harness (2) and route the wiring harness through the transmission case housing bore.
    2. Fig 2: Green, Yellow, Red & Orange Wire Harness Connectors
    GM1359040Courtesy of GENERAL MOTORS CORP.
  2. Connect the green wire harness connector to the B shift solenoid valve (470).
  3. Connect the yellow wire harness connector to the TCC solenoid valve (468).
  4. Connect the red wire harness connector to the A shift solenoid valve (466).
  5. Connect the orange wire harness connector to the C shift solenoid valve (465).
    6. Fig 3: Transmission Wiring Harness & Bolt
    GM1206253Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the transmission wiring harness assembly (2).
  7. Install the transmission wiring harness M6 x 1.0 x 20 mm bolt (1).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

scientia non olet · About LEMON Manuals