Transmission Fluid Cooler Pipe Fitting Replacement

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission Fluid Cooler Pipe Fittings & Sealing Washers

Courtesy of GENERAL MOTORS CORP.

Remove both transmission fluid cooler pipe fittings (61) and sealing washers (50) from the transmission case.
Inspect the fluid cooler pipe fittings for damage and replace as needed.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Using new sealing washers (50), install both transmission fluid cooler pipe fittings (61).
Tighten: Tighten the fittings to 20 N.m (14 lb in)