Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Heating The Transmission Case Using J 25070

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Always replace the tapered roller bearing and the race as a set.

NOTE: Do not heat the component over the specified value or damage could occur.

Using J 25070 heat the transmission case (31).
Do not heat the housing greater than 100°C (212°F).
Remove the following components:
- Front differential tapered rear roller bearing race (908)
- Front differential rear bearing race spacer (909)
- Front differential bearing race selective shim (910)
Refer to Front Differential Rotational Torque Measurement in order to determine the correct size of the front differential bearing race selective shim (910).