LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Transfer Case Input Gear Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Heating The Transmission Case Using J 25070
    GM1359030Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not heat the component over the specified value or damage could occur.
    IMPORTANT: If a slide hammer and puller are being used without heating the case, the bearing will come apart.
  1. Using J 25070  , heat the transmission case (31) in order to remove the transfer case input gear bearing (914).

    Do not heat the transmission case greater than 100°C (212°F).

  2. Using the J 26941  ,. See Special Tools .SA9133T-1  , and the SA9133T  remove the bearing after the case is warm. See Special Tools .
scientia non olet · About LEMON Manuals