Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Input Gear Bearing & Transmission Case

Courtesy of GENERAL MOTORS CORP.

Install the transfer case input gear 40 x 80 x 16.5 mm bearing (914) into the transmission case (31) in the direction shown in the insert.

Fig 2: Installing The Transfer Case Input Gear Bearing Using DT 46415 & EN 46342

Courtesy of GENERAL MOTORS CORP.

Using DT 46415 (2) and EN 46342 (1), install the transfer case input gear bearing (914) until it bottoms out in the transmission case (31). See Special Tools .