Torque Converter Clutch Lock Up Pressure Control Solenoid Installation
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install a 8 x 53 mm TCC apply pressure control solenoid fluid feed passage tube (11) with the filter end facing the transmission case hole (2).
- Measure from the top of the 8 x 53 mm fluid passage tube (11) to the machined surface of the transmission case (31). This is the installed height (a) of the fluid passage tube (11).
- If the measurement between the top of the tube and the case machined surface is approximately 7 mm (0.3 in), the tube is correctly installed in the accumulator fluid passage port.
- If the measurement is greater than 7 mm (0.3 in), install the fluid passage tube again until it is correctly seated in the accumulator body.
- Install a 8 x 36 mm TCC lock-up pressure control solenoid fluid apply passage pipe (10) with the filter end facing the transmission case.
- Install the following components into the transmission case:
- A 8 x 25.2 mm TCC lock-up pressure control solenoid fluid apply passage pipe (13)
- A new TCC apply pressure control solenoid gasket (12)
- Install both 7.7 x 2.3 mm clutch pressure control fluid passage pipe O-ring seals (9) over the fluid feed passage tubes.
- Install the TCC apply pressure control solenoid assembly (7).
- Install the 4 TCC pressure control solenoid valve M6 x 1.0 x 30 mm bolts (6).
Tighten: Tighten the bolts to 12 N.m (106 lb in).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
IMPORTANT:
Do not damage any of the TCC lock-up pressure control fluid passage pipe O-ring seals (9) during installation.