Removal Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the following steel check balls from the servo valve body (306):
- 1st clutch accumulator check valve (311)
- 1st clutch check valve (318)
- 2nd clutch check valve (319)
- Remove the 1st accumulator choke (326).
- Remove the valve bore plug retainer clip (310) from the servo valve body, then remove the following components:
- The valve bore plug (308)
- The clutch pressure control (CPC) valve (308)
- The CPC valve return spring (307)
- Remove the following:
- Valve bore plug retainer clip (310), bore plug (315), reverse CPC valve (314), and Reverse CPC valve return spring (313).
- Valve bore plug retainer clip (310), bore plug (309), return spring (317), and servo control valve (316).
- Valve bore plug retainer clip (310), bore plug (309), return spring (320), and shift valve C (321).
- Valve bore plug retainer clip (310), bore plug (309), CPC valve A (323), and return spring (324).
- Valve bore retainer (302), return spring (303), kick-down valve (304), and kick-down short valve (305).
CAUTION:
Valve springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result.
NOTE:
Do not use a magnet in order to remove the control valve body ball check valves. This may magnetize the control valve body ball check valves, causing metal particles to stick to them.
CAUTION:
Valve springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result.