LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Reverse Idler Gear Replacement >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Reverse Idler Gear Retaining Ring, Thrust Washer, Idler Gear & Bearings
    GM1542303Courtesy of GENERAL MOTORS CORP.
  1. Remove the reverse idler gear retaining ring (525).
  2. Remove the following components from the reverse idler gear returning plate assembly (531):
    • The reverse idler gear thrust washer (526).
    • The reverse idler gear (527).
    • Both reverse idler gear inner bearings (528).
    • The lower reverse idler gear thrust washer (526).
scientia non olet · About LEMON Manuals