Manual Shift Detent Lever and Park Pawl Actuator with Linkage Assembly Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Park Pawl Actuator Shaft Assembly

Courtesy of GENERAL MOTORS CORP.

Insert the smaller end of the park pawl actuator shaft assembly (932) into the correct hole location in the torque converter housing assembly (150).
Insert the park pawl shaft end of the assembly into the park pawl actuator shaft front bearing (134) located in the upper center section of the torque converter housing (150).

Fig 2: Manual Shift Shaft, Detent Roller Spring & Manual Valve

Courtesy of GENERAL MOTORS CORP.

Align the park pawl actuator shaft control lever pin with the manual valve (235) located in the main control valve body assembly (250).
Install the manual shift shaft detent roller spring (936) to the manual shift shaft (932) and the smaller end of the spring to the manual shift shaft detent roller (935).