LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> General Valve Body Service Instructions >> Valve Body Valve Installation

Valve Body Valve Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Valves & Springs In Sequence
    GM1203956Courtesy of GENERAL MOTORS CORP.
  1. Coat all parts with automatic transmission fluid before assembly.
  2. Install the valve(s) and spring(s) in the sequence shown for the main control valve body, servo valve body, regulator valve body, and accumulator body.
  3. Secure the bore plug with the correct bore plug retainer.
    4. Fig 2: Valves, Valve Springs & Spring Retainer
    GM1203957Courtesy of GENERAL MOTORS CORP.
  4. Install the correct valve(s) (A) and valve spring(s) (B) in the correct valve body bore. Push the valve spring in with a screwdriver, and then install the correct spring retainer (C).
scientia non olet · About LEMON Manuals