LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Front Differential Assembly Overhaul >> Bearing Installation Procedure

Bearing Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Front Differential Tapered Front/Rear Roller Bearing Using DT 46432
    GM1205915Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the bearings are pressed on completely. There should be no clearance between the bearing and the front differential assembly.
  1. Using the 45 mm end of DT 46432  and a hydraulic press, install the front differential tapered front roller bearing (902) on the front differential assembly. See Special Tools .
  2. Using the 45 mm end of DT 46432  and a hydraulic press, install the front differential tapered rear roller bearing (907) on the front differential assembly. See Special Tools .
scientia non olet · About LEMON Manuals