Clutch Pressure Control Solenoid Manifold Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: CPC Solenoid Manifold Locating Pins & Gasket

Courtesy of GENERAL MOTORS CORP.

Install two 8 x 14 mm clutch pressure control (CPC) solenoid manifold locating pins (83) into the transmission case (31).
Install the CPC solenoid manifold gasket (82).

Fig 2: CPC Solenoid Manifold Bolts Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the CPC solenoid manifold (84).
Install the seven M6 x 1.0 x 35 mm CPC solenoid manifold bolts (85).

Tighten: Tighten the bolts to 12 N.m (106 lb in) in the sequence shown.