Clutch Pressure Control Solenoid Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: CPC Solenoid Fluid Pipes & Transmission Case

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Install the fluid feed pipes with the filter side of the pipe into the transmission case as shown in insert.

Install a 8 x 105.8 mm clutch pressure control (CPC) solenoid fluid pipe (14) into the transmission case (31).
Install 2 8 x 58.3 mm CPC solenoid fluid pipes (15), (19) into the transmission case (31).

Fig 2: CPC Solenoid Gasket & O-Ring Seals

Courtesy of GENERAL MOTORS CORP.

Install the new CPC solenoid gasket (20) to the clutch pressure control solenoid manifold (84).

IMPORTANT: Do not damage the O-ring seals (9) during installation.

Install a 7.7 x 2.3 mm fluid pipe O-ring seal (9) over each of the 3 fluid passage pipes.

Fig 3: CPC Solenoid Valve & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the CPC solenoid valve assembly (18) onto the solenoid cover (84).
Install the following CPC solenoid valve bolts:
- 5 M6 x 1.0 x 25 mm bolts (17)
- A M6 x 1.0 x 55 mm bolt (16)

Fig 4: Clutch Pressure Control Solenoid Bolts Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the bolts in the sequence shown.
Tighten: Tighten the bolts to 12 N.m (106 lb in).