LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> 3rd and 4th Clutch Fluid Pressure Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Third & Fourth Clutch Fluid Pressure Switch & Components
    GM1632043Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the 3rd clutch pressure switch (25) with a new 3rd clutch pressure switch seal (26) into the transmission case (31).

    Tighten:  Tighten the pressure switches to 20 N.m (14 lb ft)

  2. Install the 4th clutch pressure switch (5) with a new 4th clutch pressure switch seal (4) into the transmission case (31).

    Tighten:  Tighten the pressure switches to 20 N.m (14 lb ft)

  3. Install the 4th clutch pressure switch harness (952) on the 4th clutch pressure switch.
  4. Install the engine wire harness bracket (40) and engine wiring harness bolt (39).

    Tighten:  Tighten the engine wiring harness bolt to 12 N.m (106 lb in).

scientia non olet · About LEMON Manuals