LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> 3rd Clutch Shaft Rear Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing 3rd Clutch Shaft Rear Bearing Using DT 46424, SA9133T & SA9133T-1
    GM1203912Courtesy of GENERAL MOTORS CORP.
  1. Using the DT 46424  (1), SA9133T  (2) and SA9133T-1  (3), remove the 3rd clutch shaft rear bearing (65) from the transmission case. See Special Tools .
  2. Inspect the bearing for wear or damage. Replace as needed.
scientia non olet · About LEMON Manuals