LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1828 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions >> Shifter Assemble

Shifter Assemble

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Shift Rod Assembly
    GM680444Courtesy of GENERAL MOTORS CORP.
  1. Install the inner spring seat (4) onto the shift rod (5).
  2. Install the inner spring (3).
  3. Install the outer spring seat (2).
  4. Install NEW retainers (1).
    5. Fig 2: View Of Shifter Shift Lever, Roll Pin, Bushing, Seals, Cover, & Bearing
    GM680437Courtesy of GENERAL MOTORS CORP.
  5. Install the shift cover (5).
  6. Install the shift cover bushing (3), if removed.
  7. Install the shift lever (1).
  8. Install a new roll pin (2).
    9. Fig 3: View Of Select Lever & Components
    GM680439Courtesy of GENERAL MOTORS CORP.
  9. Install the select lever (4).
  10. Install the washer (2).
  11. Install the retainer (1).
    12. Fig 4: View Of Roll Pins & Control Levers
    GM680431Courtesy of GENERAL MOTORS CORP.
  12. Install the outer spring (1).
  13. Install the end cap (2).
  14. Install the inner control lever (4) into the outer control lever (3).
  15. Install the control levers onto the shaft.
    16. IMPORTANT: Properly support the inner control lever (4) when installing the roll pin. Do not support the inner control lever (4) with the outer control lever (3).
  16. Install a new roll pin (5).
    17. IMPORTANT: Install the reverse lockout inhibit roll pin 1/3 to 1/4 way into the shaft. The pin must activate the reverse inhibit lever.
  17. Install a new reverse lockout inhibit roll pin (6).
scientia non olet · About LEMON Manuals