Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Reverse Lamp Switch

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the backup lamp switch.
Tighten: Tighten the switch to 18 N.m (13 lb ft).

Fig 2: Locating Backup Light Connector & VSS Connector

Courtesy of GENERAL MOTORS CORP.

Connect the backup lamp switch electrical connector (1).
Lower the vehicle.