LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1828 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions >> Axle Shaft Oil Seal Replacement (Right) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Differential Output Shaft Seal
    GM756689Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Prior to installing the seal, inspect the SA9113T  for nicks or burrs that may damage the seal lip.
  1. Using the SA9113T  , install the axle seal. Ensure the seal is lined up with the bore during installation.
  2. Install the intermediate drive shaft. Refer to Intermediate Shaft Replacement (L61) or Intermediate Shaft Replacement (L66) .
  3. Install the wheel and tire. Refer to Tire and Wheel Removal and Installation .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals