Test Description
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
The number below refers to the step number on the diagnostic table.
- 5: This step inspects the driveline components that may be the cause of the clunk noise. The noise may resonate to the transaxle.
Transmission Clunk on Acceleration or Deceleration
| Step | Action | Yes | No |
|---|---|---|---|
| DEFINITION: A clunk is heard and/or felt on acceleration or deceleration. | |||
| 1 | Did you review the Symptoms - Manual Transmission and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Manual Transmission |
| 2 | Inspect the engine mounts for being loose or damaged. Refer to Engine Mount Inspection
. Did you find and repair the condition? |
Go to Step 7 | Go to Step 3 |
| 3 | Inspect the transaxle mounts for being loose or damaged. Refer to Transmission Mount Inspection . Did you find and repair the condition? |
Go to Step 7 | Go to Step 4 |
| 4 | Inspect the transaxle to engine fasteners for being loose or missing. Refer to Fastener Tightening Specifications . Did you find and repair the condition? |
Go to Step 7 | Go to Step 5 |
| 5 | Inspect the driveline for causing the clunk. Refer to Diagnostic Starting Point - Wheel Drive Shafts
. Did you find and repair the condition? |
Go to Step 7 | Go to Step 6 |
| 6 |
|
Go to Step 7 | Go to Diagnostic Aids In This Test |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 1 |