LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine Mechanical - 3.5L (L66)) >> Repair Instructions >> On Vehicle Repair Instructions >> Oil Flow Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Flow Control Module
    GM1236195Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW oil flow control module screen.
    2. NOTE: Refer to Fastener Notice .
  2. Install the oil flow control module and bolts.

    Tighten:  Tighten the bolts to 22 N.m (16 lb ft).

  3. Install a new oil filter. Refer to Engine Oil and Oil Filter Replacement .
  4. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals