LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine Mechanical - 3.5L (L66)) >> Repair Instructions >> On Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Crankshaft Oil Seal Into Housing
    GM897004Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the lip of the oil seal with a light coat of grease.
  2. Use the EN 46342  (1) and the. See Special Tools .EN 46351  (2) in order to install the seal squarely into the housing. See Special Tools .
    3. Fig 2: View Of Crankshaft Oil Seal
    GM897006Courtesy of GENERAL MOTORS CORP.
  3. Drive the new crankshaft oil seal until the tool bottoms onto the housing. A properly installed seal will be flush with the face of the housing.
  4. Install the engine flywheel. Refer to Engine Flywheel Replacement .
scientia non olet · About LEMON Manuals