LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine Mechanical - 3.5L (L66)) >> Repair Instructions >> On Vehicle Repair Instructions >> Camshaft Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Journals
    GM897137Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the camshaft journals and bores with clean engine oil.
    2. NOTE: Refer to Fastener Notice .
  2. Install the camshaft, NEW O-ring, cap, and bolts.

    Tighten:  Tighten the bolts to 22 N.m (16 lb ft).

  3. Install a new camshaft seal. Refer to Camshaft Oil Seal Replacement .
    4. Fig 2: Rocker Shaft Right Side Retaining Bolt Loosening/Tightening Sequence
    GM1308051Courtesy of GENERAL MOTORS CORP.
  4. Install the rocker arm and shaft assembly. Refer to Valve Rocker Arm and Shaft Replacement .
  5. Install the right camshaft drive sprocket. Refer to Camshaft Drive Sprocket Replacement - Right Side .
  6. Install the right rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Right Side .
  7. Install the PCM. Refer to Powertrain Control Module Replacement .
  8. Connect the engine harness connectors.
  9. Connect the fuel feed line to the fuel rail. Refer to Fuel Hose/Pipes Replacement - Chassis .
  10. Install the underhood fuse/relay box.
  11. Install the battery tray. Refer to Battery Tray Replacement (3.5L (L66)) .
  12. Install the battery. Refer to Battery Replacement (2.2L (L61) and 3.5L (L66)) .
scientia non olet · About LEMON Manuals