LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine Mechanical - 3.5L (L66)) >> Repair Instructions >> Off Vehicle Repair Instructions >> Oil Flow Control Module Installation

Oil Flow Control Module Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Oil Control Module
    GM897069Courtesy of GENERAL MOTORS CORP.
  1. Install the spring (413) and valve (414). The valve must move freely in the bore.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the NEW O-ring (415), solenoid (416) and bolts (417).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  3. Install a NEW O-ring (418).
  4. Install the module (412) and bolts (436).

    Tighten:  Tighten the bolts to 22 N.m (16 lb ft).

  5. Install 2 M20 x 1.5 mm nuts onto the fitting (411).
  6. Install the fitting (411), if required.

    Tighten:  Tighten the fitting to 49 N.m (36 lb ft).

  7. Remove the 2 M20 x 1.5 mm nuts from the fitting.
  8. Install a NEW O-ring (440) and switch (437).

    Tighten:  Tighten the switch to 22 N.m (16 lb ft).

scientia non olet · About LEMON Manuals