LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine Mechanical - 3.5L (L66)) >> Repair Instructions >> Off Vehicle Repair Instructions >> Intake Manifold Removal

Intake Manifold Removal

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold
    GM897026Courtesy of GENERAL MOTORS CORP.
  1. Remove the bolts (727), EVAP valve with hoses (718) and clamps (719).
  2. Remove the positive crankcase ventilation (PCV) hose (548) and clamps (549).
  3. Remove the intake air temperature (IAT) sensor (715) and O-ring (714).
  4. Remove the bolts (513) and nuts (514).
  5. Remove the cover (512) and gasket (511).
  6. Remove the studs (515), if required.
    7. Fig 2: Identifying Bolts, Nuts, Manifold, Gaskets & Spacer
    GM897027Courtesy of GENERAL MOTORS CORP.
  7. Remove the bolts (508) and nuts (507).
  8. Remove the manifold (500), gaskets (520) and spacer (521).
    9. Fig 3: View Of Exhaust Gas Recirculation, Tube & Bolts
    GM897029Courtesy of GENERAL MOTORS CORP.
  9. Remove the nuts (503) and bolts (504), if required.
  10. Remove the covers (502 and 505), gaskets (501 and 506) and studs (553), if required.
  11. Remove the bolts (510) and exhaust gas recirculation (EGR) tube (509), if required.
  12. Remove the cap (554).
  13. Remove the bolts (729) and dampener (728), if required.
scientia non olet · About LEMON Manuals