LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1814 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Tensioner Tool
    GM951829Courtesy of GENERAL MOTORS CORP.
    CAUTION: The tensioner assembly's internal parts are not serviceable. To avoid injury, do not disassemble the tensioner.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Raise the vehicle on the hoist. Refer to Lifting and Jacking the Vehicle .
  3. Remove the right wheel and the splash shield.
  4. Install the J 44811  onto the tensioner.
  5. Remove the accessory drive belt.
    6. Fig 2: Removing & Installing Belt Tensioner Bolt
    GM894941Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: To remove the tensioner bolt an access hole has been provided through the inner and outer engine rail.
  6. Remove the tensioner assembly.
  7. Remove the tensioner bolt.
scientia non olet · About LEMON Manuals