LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1814 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Tensioner Tool
    GM951829Courtesy of GENERAL MOTORS CORP.
    CAUTION: The tensioner assembly's internal parts are not serviceable. To avoid injury, do not disassemble the tensioner.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (2.2L (L61) and 3.5L (L66))
  2. Raise the vehicle on the hoist. Refer to Lifting and Jacking the Vehicle .
  3. Remove the right wheel and the splash shield.
  4. Install the J 44811  onto the tensioner.
  5. Remove the accessory drive belt.
    6. Fig 2: Removing & Installing Belt Tensioner Bolt
    GM894941Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: To remove the tensioner bolt an access hole has been provided through the inner and outer engine rail.
  6. Remove the tensioner assembly.
  7. Remove the tensioner bolt.
scientia non olet · About LEMON Manuals