LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1814 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Flywheel/Flexplate
    GM894934Courtesy of GENERAL MOTORS CORP.
  1. Remove the transaxle assembly. Refer to Transmission Replacement for the 4T45-E transaxle or Transmission Replacement for the Getrag 5 speed transmission.
  2. If servicing the rear main seal on a manual transaxle vehicle, refer to Clutch Assembly Replacement .
  3. Install the J 43653  . See Special Tools .
    4. Fig 2: Removing/Installing Flexplate/Flywheel Bolts
    GM894936Courtesy of GENERAL MOTORS CORP.
  4. Remove the flexplate/flywheel bolts and discard.
  5. Remove the flexplate/flywheel assembly.
  6. Clean the thread adhesive from the flywheel bolts. Use a nylon bristle to clean the bolt holes from the crankshaft.
  7. Remove the J 43653  . See Special Tools .
    8. IMPORTANT: Do not damage the block or sealing surface when removing the rear main seal.
  8. Remove the rear main seal by using a seal removal tool, or by inserting a self tapping screw and slide hammer into the seal.
scientia non olet · About LEMON Manuals