Engine Flywheel Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 38122-A Crankshaft Balancer Holder. See Special Tools .
J 45059 Angle Meter. See Special Tools .

Fig 1: View Of Flywheel

Courtesy of GENERAL MOTORS CORP.

Install the flywheel.
Install the NEW bolts.

NOTE: Refer to FASTENER NOTICE .

Holding the crankshaft balancer with the J 38122-A , tighten the bolts evenly. See Special Tools .
Tighten: Tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees using the J 45059 . See Special Tools .