LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1814 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Block Assemble

Engine Block Assemble

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Passage Plug, Oil Flow Check Valve & Water Jacket Drain Plug
    GM412447Courtesy of GENERAL MOTORS CORP.
  1. Install the drain plug in the water pump.
  2. Apply sealer GM P/N 12346004 (Canadian P/N 10953480) to the plug before installation.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the coolant jacket plugs.

    Tighten:  Tighten the coolant jacket plug to 35 N.m (26 lb ft).

  4. Install the rear oil passage plugs.
  5. Apply sealer GM P/N 12346004 (Canadian P/N 10953480 to the plugs before installation.

    Tighten:  Tighten the oil passage plug to 60 N.m (44 lb ft).

  6. Install the other oil passage plugs.
  7. Apply sealer GM P/N 12346004 (Canadian P/N 10953480) to the plug before installation.

    Tighten:  Tighten the oil passage plugs to 35 N.m (26 lb ft).

    8. Fig 2: View Of Crankshaft Position Sensor
    GM630345Courtesy of GENERAL MOTORS CORP.
  8. Lubricate the crankshaft position sensor O-ring with engine oil.
  9. Install the crankshaft position sensor and bolt.

    Tighten:  Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).

    10. Fig 3: View Of Engine Oil Pressure Sensor
    GM630350Courtesy of GENERAL MOTORS CORP.
  10. Install the oil pressure switch.

    Tighten:  Tighten the oil pressure switch to 10 N.m (89 lb in).

    11. Fig 4: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
  11. Install the knock sensor and bolt.

    Tighten:  Tighten the knock sensor bolt to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals