LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1812 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Positive Cable Replacement (3.5L (L66)) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Negative Battery Cable To The Transmission Bracket
    GM1228615Courtesy of GENERAL MOTORS CORP.
  1. Route the battery cable through the engine compartment and connect to the cable retainers.
  2. Connect the positive battery cable to the generator.
  3. Connect the positive battery cable to the starter (2).
    4. Fig 2: Removing/Installing Underhood Electrical Wiring
    GM934966Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Connect the positive battery cable to the UHJB (2).

    Tighten:  Tighten the positive cable to UHJB to 17 N.m (13 lb ft).

  5. Install the UHJB cover (1).
  6. Connect the positive battery cable to the battery.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (2.2L (L61) and 3.5L (L66))  or Battery Negative Cable Disconnection and Connection (2.4L (LAT)) .
scientia non olet · About LEMON Manuals